If your drawers will have an overlay front, notch the drawer box, photo below, so the slide sits flush with the front face of the drawer box. Position the drawer member over the centerline on the drawer, with the front of the drawer member 5. Close the drawer (Model 7957 only). Place the profile on the side of the drawer making sure thart the front of the profile is flush with the front of the drawer. As for the drawer dimensions, you’ll want to read the instructions that come with the slides, or measure their thickness, and use this to figure the final width of the outsides of the drawer. For inset drawers, align the slide flush with the drawer front and centered across its width. Centerline 758 Series Heavy Duty Full Extension Slide Before installing the slides, separate the cabinet and drawer members. Use the centerline mark (number) to center the profile on the drawer… † Attach drawer profile portion of the slide to the side of the drawer on centerline as illustrated with the appropriate screws. Accuride warrants its Accuride–branded drawer slides against defects in material and workmanship for so long as the original purchaser owns them. Assemble the Drawer: 6. Next you will use your drill to attach the screws to secure your slides into place. Note: First hole on cabinet member is 35mm from front edge of slide. 2. 1. The full-length drawer slide catch is made of the same kiln-dried wood as the drawer slide itself, and fits along the full length of the drawer slide. If necessary, use more screws to secure slides and complete installation. 8. 5. It supports the entire drawer much better than a slide catch mounted only at the back of the drawer. Insert the drawer into the cabinet-mounted slides and test its fit. Connect the drawer/shelf by inserting the drawer member between the ball bearings and carefully pushing the drawer until closed. Installation Instructions † Slide mounting bracket onto rear of the cabinet profile and slide drawer profiles mounted on drawer into the middle profile and all the way into the closed position. Centerline 714 Series Center Mount Slides 1. If the drawer binds, loosen the screw on the rear mounts and adjust the bracket side-to-side until the drawer slides smoothly. The extension slides I’m using are 1/2″ thick, so my drawer is 1″ narrower than the opening of the desk that will house the drawer. Secure the drawer member to the drawer box/shelf with screws in the front and back vertical slots. The first slide inward can sometimes push a bit tougher, but once the tracks are engaged, the drawer should slide back out and in smoothly. Use a straightedge to check the drawer front's fit to the face frame, photo below. Tighten all screws. • Slide mounting bracket onto rear of the cabinet profile and slide drawer profiles mounted on drawer into the middle profile and all the way into the closed position. 3. Open the drawer and adjust slide position until movement is smooth. Open the slide and separate the two members (friction fit). Place the ends of the slides attached to the drawers into the tracks inside the cabinet. fully forward. Note that the release trigger moves downward on the left hand slide, and upward on the right hand slide. Pressing evenly on each side of the drawer, slide the drawer into place. Now let’s attach the drawer profile. • Attach drawer profile portion of the slide to the side of the drawer on centerline as illustrated with the appropriate screws. READ MORE > 7. Attach to the drawer first. Hold the drawer level in front of the cabinet. Install drawer into cabinet. Slide the intermediate member to the front of the cabinet member. Install Cabinet Members First: 1. * This warranty does not cover drawer slides which have been damaged due to abuse, improper installation, excessive loads, or any use contrary to the instructions accompanying the product. 7. Measure the width of the drawer box and mark centerlines on both the underside of the drawer and the drawer opening in the cabinet. of the drawer/shelf.